TECHNIQUE TO RECONSTRUCT BAND 6 REFLECTANCE INFORMATION OF AQUA MODIS
DOI:
https://doi.org/10.30536/j.ijreses.2016.v13.a2449Keywords:
data reconstruction, MODIS band 6, AquaAbstract
Remote sensing data could experience damage due to sensor failure or atmospheric condition. Reconstruction technique to retrieve the missing information had been widely developed in the past few years. This writing aimed to provide a technique to recover reflectance information of Aqua Moderate Resolution Imaging Spectroradiometer (MODIS) Band 6. Since Band 6 Aqua MODIS experienced sensor failure, lots of information would be missing. There were three kinds of methods used in repairing such damage. Two of which were categorized as spatial-based methods, i.e. NaN interpolation method and tensor completion method. Whereas, another method was a spectral-based one. NaN was an interpolation method to reconstruct missing value; while tensor completion method utilized low rank approximation, and spectral method used correlation between Band 6 and Band 7 which had near wavelength. Implementation of these methods was resulted in reconstruction of Aqua Modis Band 6 data which was damaged due to detector disfunction on Aqua Satellite. Peak Signal to Noise Ratio (PSNR) value of this method was 41 dB, meaning that reconstruction technique provided positive impacts for data improvement.
Downloads
Published
Issue
Section
License
Copyright (c) 2016 Author (s)
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
Copyright Notice for the International Journal of Remote Sensing and Earth Sciences (IJReSES)
Copyright Holder: Author(s).
By submitting an article to IJReSES, author(s) agree to the following terms:
1. Grant of Publishing Rights: Authors grant IJReSES the license to publish the article and to identify itself as the original publisher. This includes the right to make the article available in all forms and media.
2. Commercial Rights: Authors grant IJReSES the rights to produce and sell hardcopy volumes of the journal. These volumes may be purchased by libraries, individuals, or other entities.
3. Third-Party Use: Authors agree to allow any third party to freely use the article, provided that the original authors are credited and the article is cited appropriately. This facilitates the dissemination and impact of the work.
4. Creative Commons License: The article is distributed under the Creative Commons Attribution non Commercial Share Alike 4.0 License (CC BY-NC-SA 4.0). This license allows others to distribute, remix, adapt, and build upon the work, even commercially, as long as the original author is credited for the original creation.
5. Associated Published Material: Unless otherwise stated, any associated published material (such as supplementary data, graphics, and multimedia) is distributed under the same CC BY-NC-SA 4.0 License.
By adhering to these terms, authors ensure the wide dissemination and accessibility of their work, contributing to the advancement of knowledge in the fields of remote sensing and earth sciences.
