APPLICATION OF SEISMIC DATA PROCESSING FOR SEABED IMAGING

Authors

  • Henry M. Manik Division of Ocean Acoustics and Instrumentation Department of Marine Science and Technology, Bogor Agricultural University Kampus IPB Darmaga
  • Susilo Hadi Marine Geological Institute, Bandung

DOI:

https://doi.org/10.30536/j.ijreses.2010.v7.a1545

Keywords:

Marine Geology, Seismic

Abstract

The research was conducted in April-May 2010 in North Maluku watersbelonging to the District Luwuk Banggai, Central Sulawesi Province. This area is located atcoordinates 2 ° S - 4 ° S and 123 ° E - 126 ° east. Data processing was done at OceanAcoustics Laboratory, Department of Marine Science and Technology, Bogor AgriculturalUniversity and Marine Geological Institute (MGI) in Bandung. Seismic data processingusing the data in SEG-Y format. The data was computed with Seisee software and bandpass filtering using Matlab. Based on the results of research, it is evident that increasing thefrequency band was followed by the higher the resolution. Sampling point 30 in the form ofsandy clay sediments has an impedance value of 2.49 and the value of reflection coefficientof 0.23. While the sampling point 31 in the form of silty clay in the study showed the valueof the impedance of 1,93 with the reflection coefficient of 0.11.

Downloads

Published

2025-11-26

Issue

Vol. 7 No. 1 (2010)

Section

Articles

License

Copyright (c) 2010 Author (S)

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.

Copyright Notice for the International Journal of Remote Sensing and Earth Sciences (IJReSES)

Copyright Holder: Author(s).

By submitting an article to IJReSES, author(s) agree to the following terms:

1. Grant of Publishing Rights: Authors grant IJReSES the license to publish the article and to identify itself as the original publisher. This includes the right to make the article available in all forms and media.

2. Commercial Rights: Authors grant IJReSES the rights to produce and sell hardcopy volumes of the journal. These volumes may be purchased by libraries, individuals, or other entities.

3. Third-Party Use: Authors agree to allow any third party to freely use the article, provided that the original authors are credited and the article is cited appropriately. This facilitates the dissemination and impact of the work.

4. Creative Commons License: The article is distributed under the Creative Commons Attribution non Commercial Share Alike 4.0 License (CC BY-NC-SA 4.0). This license allows others to distribute, remix, adapt, and build upon the work, even commercially, as long as the original author is credited for the original creation.

5. Associated Published Material: Unless otherwise stated, any associated published material (such as supplementary data, graphics, and multimedia) is distributed under the same CC BY-NC-SA 4.0 License.

By adhering to these terms, authors ensure the wide dissemination and accessibility of their work, contributing to the advancement of knowledge in the fields of remote sensing and earth sciences.