THE POTENTIAL OF INDONESIAN GRAPHITE AS RDE FUEL MATRIX
DOI:
https://doi.org/10.17146/jsmi.2019.20.2.5472Keywords:
Natural graphite, matrix, fuel, PBR, RDE, characterizationAbstract
THE POTENTIAL OF INDONESIAN GRAPHITE AS RDE FUEL MATRIX. The development plan of Ex- perimental Power Reactor (RDE) in Indonesia is non-commercial and leads to the technology type of Pebble Bed Reactor (PBR) - High Temperature Gas Cooled Reactor (HTGR). The fuel used for PBR reactors is kernel dispersed in spherical fuel elements. The matrix used in PBR nuclear fuel is graphite which functions as a neutron moderator, fuel protective material and heat conductor. Domestication of the domestic fuel matrix needs to be conducted to improve national independence. Therefore, it is necessary to do research on the potential of local graphite to be used as RDE fuel matrix. This study focused on the identification and characterization of local and commercial graphite. The results are compared with the literature, how far it is fulfilling nuclear grade graphite for PBR fuel matrix. Characterization of graphite includes phase analysis with XRD, micro- structure with SEM, surface area/porosity, impurities determination with AAS, ICP-OES and NAA, equivalent boron content, carbon content, density, particle size distribution and ash content. The characterization results show that the carbon content obtained was 87.0 ± 4.2% for local graphite and 100% for commercial graphite. Meanwhile, for the purposes of nuclear graphite it requires a carbon content of >99%. The impurity content in local and commercial graphite still does not meet the RDE fuel matrix standard. The results of XRD analysis show that the local graphite phase is the same as the commercial graphite phase, namely the 2H graphite hexagonal crystal system with the lattice group of P 63/mmc. Particle size distribution and surface area of local graphite are higher compared to nuclear graphite literature. The ash content of commercial graphite was 0.236 ± 0.029 and local graphite was 9.587 ± 0.010%. The results of this study indicate that the local graphite from the flotation still requires a further refinement process to obtain local graphite that can be used as a fuel matrix for RDE.
Downloads
References
. T. Setiadipura, S. Bakhri, G. R. Sunaryo, and D. S. Wisnusubroto, “Cooling passive safety features of Reaktor Daya Eksperimental,” AIP Conf. Proc., vol. 1984, 2018.
. C. Tang, Y. Tang, J. Zhu, Y. Zou, J. Li, and X. Ni, “Design and manufacture of the fuel element for the 10 MW high temperature gas-cooled reactor,” Nucl. Eng. Des., vol. 218, no. 1–3, pp. 91–102, 2002.
. H. Zhao, T. Liang, J. Zhang, J. He, Y. Zou, and C. Tang, “Manufacture and characteristics of spherical fuel elements for the HTR-10,” Nucl. Eng. Des., vol. 236, no. 5–6, pp. 643–647, 2006.
. S. Yeo, J. Yun, S. Kim, M. S. Cho, and Y. W. Lee, “Fabrication methods and anisotropic properties of graphite matrix compacts for use in HTGR,” J. Nucl. Mater., vol. 499, pp. 383–393, 2018.
. IAEA, “High Temperature Gas Cooled Reactor Fuels and Materials,” IAEA Tecdoc 1645, pp. 1– 182, 2010.
. P. P. Magampa, N. Manyala, and W. W. Focke, “Properties of graphite composites based on natural and synthetic graphite powders and a phenolic novolac binder,” J. Nucl. Mater., vol. 436, no. 1–3, pp. 76–83, 2013.
. X. Zhou et al., “Study on the Comprehensive Properties and Microstructures of A3-3 Matrix Graphite Related to the High Temperature Purification Treatment,” Hindawi Sci. Technol. Nucl. Install., 2018.
. X. W. Zhou, Y. P. Tang, Z. M. Lu, J. Zhang, and B. Liu, “Nuclear graphite for high temperature gas-cooled reactors,” Xinxing Tan Cailiao/New Carbon Mater., vol. 32, no. 3, pp. 193–204, 2017.
. T. Indrayati and Sudaryadi, “Penyiapan umpan grafitisasi dengan metoda granulasi bertahap,” Pros. PPI - PDIPTN, pp. 278–282, 2007.
. F. F. Florena et al., “Floatability study of graphite ore from southeast Sulawesi (Indonesia),” AIP Conf. Proc., vol. 1712, 2016.
. I. M. Joni et al., “Synthesis and dispersion of nanoparticles, and Indonesian graphite processing,” AIP Conf. Proc., vol. 1554, pp. 20– 26, 2013.
. C. Panatarani, A. O. Maulana, A. Rianto, and I. M. Joni, “Preparation of graphite oxide by sodium cholate intercalation and sonication from Indonesian natural graphite,” AIP Conf. Proc., vol. 1712, no. March 2016, 2016.
. R. Marza, W. Setiyawan, and H. Rodiana, “Keprospekan Mineral Grafit di Pulau Kalimantan dan Pulau sulawesi,” Pros. Has. Kegiat. Pus. Sumber Daya Miner. Batubara dan Panas Bumi Tahun Anggar. 2017, vol. Buku 2 : B, pp. 219–229, 2018.
. B. J. Marsden, G. N. Hall, 2012, "Graphite in gas - cooled reactors", Comprehensive Nuclear Materials Volume 4, Elsevier, Amsterdam, pp 325-390
. H.G. Maahs, D.R. Shryer, “Chemical impurity data on selected artificial graphites with comments on the catalytic effect of impurities on oxidation rate”, NASA Technical Note (NASA TN D-4212, National Aeronautic and Space Administration, Washington, D.C. 1967.
. X. Luo, X. Wang, L. Shi, X. Yu, and S. Yu, “Nuclear graphite wear properties and estimation of graphite dust production in HTR-10,” Nucl. Eng. Des., vol. 315, pp. 35–41, 2017.
. W. Windes, G. Strydom, R. Smith, J. Kane, 2014, “Role of nuclear grade graphite in controlling oxidation in modular HTGRs”, IN/EXT-14- 31720, Idaho National Laboratory, U.S. Department of Energy National Laboratory. 2014.
. ASTM, “Standard Practice for Determining Equivalent Boron Contents of Nuclear materials C 1233”. ASTM International. 1993
. IAEA, “Advances in High Temperature Gas Cooled Reactor Fuel Technology,” in IAEA TECDOC CD 1674, 2012, pp. 1–690
Downloads
Published
How to Cite
Issue
Section
License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
