Critical Heat Flux Nanofluids Measurements System Using Arduino
DOI:
https://doi.org/10.17146/tdm.2021.23.1.6005Keywords:
Critical heat flux, Nanofluids, Arduino, Voltage, CurrentAbstract
Crtical heat flux (CHF) is an important characteristic of nanofluids. The CHF measurements were carried out in nanofluid research at the Center for Applied Nuclear Science and Technology. These measurements are done manually using a variable power supply and a multimeter. However, it was difficult to record the voltage and current due to the sudden break of the wire. In this study, Arduino was used to measure CHF automatically. The voltage is applied to the wire and increases automatically along with the measurement of the voltage and current in the wire. The results of the voltage and current measurements were compared with a multimeter and were not significantly different. It can be concluded that the CHF measurement system using arduino can be used to measure nanofluid CHF.
References
Syarif D.G., Prajitno D.H., Pane J.S. Nanofluids with Enhanced CHF Prepared from Solgel Synthesized Al2O3 Nanoparticles Utilizing Urea as Chelating Agent. 2018. 1:801-814.
https://doi.org/10.2991/icst-18.2018.163
Syarif D.G., Prajitno D.H., Pane J.S. Nanofluids with Enhanced CHF Prepared from Self-Combustion Synthesized Al2O3 Nanoparticles with PEG 1000 as Fuel. IOP Conf. Ser. Mater. Sci. Eng. 2019. 515:1-8.
https://doi.org/10.1088/1757-899X/515/1/012046
Syarif D.G., Prajitno D.H., Umar E. Characteristics of Nanofluids Made from Solgel Synthesized-Al2O3 Nanoparticles using Citric Acid and PEG as Organic Agent and Bauxite as Raw Material. Mater. Sci. Forum. 2018. 929:1-9.
https://doi.org/10.4028/www.scientific.net/MSF.929.1
Syarif D.G., Prajitno D.H., Pane J.S. Effect of Calcination Temperature during Synthesis of Al2O3 from Local Bauxite on Stability and CHF of Water-Al2O3 Nanofluids. J. Aust. Ceram. Soc. 2018. 54(1):47-53.
https://doi.org/10.1007/s41779-017-0125-8
Kole M., Dey T.K. Investigations on the Pool Boiling Heat Transfer and Critical Heat Flux of ZnO-ethylene glycol nanofluids. Appl. Therm. Eng. 2012. 37:112-119.
https://doi.org/10.1016/j.applthermaleng.2011.10.066
Sheikhbahai M., Nasr Esfahany M., Etesami N. Experimental Investigation of Pool Boiling of Fe3O4/Ethylene Gycol-water Nanofluid in Electric Field. Int. J. Therm. Sci. 2012. 62:149-153.
https://doi.org/10.1016/j.ijthermalsci.2011.10.004
Hiswankar S.C., Kshirsagar J.M. Determination Of Critical Heat Flux In Pool Boiling Using ZnO Nanofluids. 2013. 2(7):2091-2015.
Kim S.H., Lee G.C., Kang J.Y., Moriyama K., Kim M.H., Park H.S. Boiling Heat Transfer and Critical Heat Flux Evaluation of the Pool Boiling on Mmicro Structured Surface. Int. J. Heat Mass Transf. 2015. 91:1140-1147.
https://doi.org/10.1016/j.ijheatmasstransfer.2015.07.120
Hendricks T.J., Krishnan S., Choi C., Chang C.H., Paul B. Enhancement of Pool Boiling Heat Transfer using Nanostructured Surfaces on Aluminum and Copper. ASME Int. Mech. Eng. Congr. Expo. Proc. 2010. 12:1025-1033.
https://doi.org/10.1115/IMECE2009-13176
Park S.D., Lee S.W., Kang S., Kim S.M., Bang I.C. Pool Boiling CHF Enhancement by Graphene-oxide Nanofluid under Nuclear Coolant Chemical Environments. Nucl. Eng. 2012. 252:184-191.
https://doi.org/10.1016/j.nucengdes.2012.07.016
Meade T. Pulse Width Modulation Using an Arduino. 2014.:1-8.
Birdayansyah R., Soedjarwanto N., Zebua O. Pengendalian Kecepatan Motor DC Menggunakan Perintah Suara Berbasis Mikrokontroler Arduino. Electrician. 2015. 9(2):97-108.
Petru L., Mazen G. PWM control of a DC Motor used to Drive a Conveyor Belt. Procedia Eng. 2015. 100:299-304.
https://doi.org/10.1016/j.proeng.2015.01.371
Kaushik S., Chouhan Y.S., Sharma N., Singh S. Automatic Fan Speed Control using Temperature and Humidity Sensor and Arduino. Int. J. Adv. Res. 2018. 4(2):453-467.
Allegro® ACS712. 2020.:1-15.
